Method of Usage
•
Connect the joint of the air pipe and power cord (Note: There are marks on the air pipe and
the cable connectors are different sizes). (Figure 9)
•
Pull the calf rest air pipe and power cord through the hole of the front dam-board, then
tighten the screws of the dam-board. (Figure 10)
•
Zip up the backrest kneading cloth. (Figure 11)
•
Plug the heat plug of the back cushion into the heat hole on the backrest, and put the back
cushion tidily on the backrest. (Figure 12)
•
The calf rest decoration cover is a card slot design, make an effort to push it during assembly
(Note: Keep the cover tight with the side), armrest installation is completed. (Figure 13)
Method of Usage
6. Calf installation
•
Install the rotating shaft in-calf with the fixed axis first. Note: The hole should be aligned with
an R shape pin assembly. (Chart 1)
•
After calf is connected and aligned with the fixed axis, insert it. (Chart 2)
•
Plug in the R pin, then move to the other side of the calf, and plug in the next R pin. (Chart 3)
•
Finished. (Chart 4)
NOTE:
•
While the machine is reclining, do not apply your body weight to the calf rest. (Chart 1)
•
When going to sit down, ensure that the massage hands are not in the seat area to avoid
discomfort. (Chart 2)
