13
1) Disconnect the LP gas cylinder from the gas grill.
(See
page 6).
Store LP cylinder outside, in a dry, well-ventilated
area, away from sources of heat or ignition.
2) Wrap the Burners with aluminum foil to prevent insects
from entering the burner holes.
3) Wipe the cooking surfaces with a light coat of cooking oil
and wrap in aluminum foil and place inside the Hood or
store inside your dwelling.
4) Place a grill cover over the grill and store it outdoors if
possible. It may be stored indoors only if the LP cylinder is
disconnected from the gas grill.
5) Before next use, remove aluminum foil and wash the
Cooking surfaces.
6) Before using the grill after periods of storage or non-use
(i.e. over winter), check your LP gas grill for gas leaks,
deterioration, proper assembly, and burner obstructions.
7) Periodically check and tighten all nuts, bolts, and screws.
Your Gas Grill comes with convenient wheels and a slide out
handle for roll-away transport. After the Grill has completely
cooled, cylinder is disconnected and the Grill has been
cleaned:
1) Fold and strap the Grill side tables over the closed Hood.
2) Slide the Left Handle Bar back under the grill.
3) Remove the leg shelf. Release the locking springs and
lower the left end of the Leg Shelf. Lift the other end off
the mounting Hooks on the right legs.
To reduce risk of any bodily injury:
· Always Lock the Grill Hood with the Strap Lock before
transporting and storing this Grill.
· Always transport the grill on the wheels and pull with
the slide bar. Do not attempt to carry the the grill by
grasping the Hood handle. The strap lock will not
support the weight.
· Be careful when towing your grill so it does not roll up
against you.
4) Swing the Gas Regulator up into its storage position
behind the front panel of the Grill and clip it into place.
(FIG. 24A)
5) Fold Legs to locked position under Grill.
6) Store Leg Shelf back in the bottom of the grill and snap
into place.
7) Store Leg Shelf back in the bottom of the grill and snap
into place.
8) Grasp the Right side Handle Bar; lift Grill on wheels and
roll the grill away to storage area.
(FIG. 24B) DO NOT
ATTEMPT TO CARRY THE GRILL BY GRASPING THE
HOOD HANDLE
.
Store Gas Regulator & Hose
Fig. 24A
Fig. 24B
Tow-away on Wheels
For Convenient Storage
Use Slide Handle
Bar for Towing
Storage Clip
Problem
Possible Cause
Solution
Burner will not light
using the ignitor
Not pausing long enough
before clicking the Ignitor
No spark
LP gas cylinder is empty
The spacing between electrode and Burner ports should be
approximately 3/16”. Make sure wire connections are secure
and burner is attached securely to brackets.
Dispose of empty cylinder and replace with a full one.
TROUBLESHOOTING
When lighting the Burner, push in and turn the Control Knob
counterclockwise to
“
I
”
when you feel resistance. Pause 4
seconds, then push in and turn the Control Knob until a click is
heard.
