3.1 BASIC TOOL REQUIRED
-
Drill, 4mm drill bit
3.2 MULTI-FIT SUPPORT BAR CONTENTS
-
1 x hollow bar centrepiece
- 2 x grub screws
-
2 x solid bar end piece
3.3 FITTING MULTI-FIT BAR
1.
Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders with
the holes facing to the ground (so the grub screws don’t rub against the tonneau), as shown above and then
with a white pencil make a mark through the small holes of the hollow bar onto the solid ends. This is where
you will drill a hole to the depth of about 1-2mm (do not go any further)
2.
Join the pieces back together and screw grub screws through the hollow bar into the holes that you drilled.
Make sure you do not over tighten the grub screws
. Refit the bar. You may kink the bar in the middle to
give it some extra height to assist with water runoff.
