AUSSIE TONNEAU ATR01146 Fitting Instructions Download Page 4

Page: 4 / 4

3.3 FITTING MULTI-FIT BAR

Insert solid bar pieces into either end of hollow tube. Adjust bar so it fits between bar bracket holders

with the holes facing to the ground (so the grub screws don’t rub against the tonneau), as shown above

and then with a white pencil make a mark through the small holes of the hollow bar onto the solid ends.

This is where you will drill a hole to the depth of about 1-2mm (do not go any further)

Join the pieces back together and screw grub screws through the hollow bar into the holes that you

drilled.

Make sure you do not over tighten the grub screws

. Refit the bar. You may kink the

bar in the middle to give it some extra height to assist with water runoff.

Summary of Contents for ATR01146

Page 2: ...against the front cabin end inside vertical surface of the tub 2 centralize the rope track Figure 1 Placement of aluminium rope track Ensure channel is above the tub s top edge Place the bar bracket with the beveled edge facing up 760mm 5mm down from top edge of tub J 1 2 Front of car Tub Front of car Figure 2 Placement of Bar Bracket Figure 3 Button ...