Ausrv X15 2021, Owner'S Manual

Page: 73 / 109

www.ausrv.com
Ph: 833 872 8778
73
Operation
FIRE OR EXPLOSION HAZARD
Failure to obey the following warnings could result in property damage,
serious injury or death.
WARNING
• This Furnace does not have a pilot. It is equipped with an ignition device that automatically lights the burner. Do
NOT
try to light the burner by hand.
•
BEFORE OPERATING THE FURNACE
, check around the Furnace area and floor for the smell of gas and check
the fitting with a leak test solution. Do
NOT
proceed if a gas odor exists around the Furnace or floor area. Follow
the instructions in the warning box on the cover page.
• Turn the gas control valve by hand
ONLY
.
NEVER
use tools. If the valve does not turn by hand, do
NOT
attempt
to repair it. Call a qualified service technician.
Read the following BEFORE proceeding
NOTICE
• During the initial firing of the Furnace, a burn-off of excess paint and oils remaining from the manufacturing
process may cause “smoking” for 5 – 10 minutes.
• The Furnace is equipped with a power switch. Gas will not flow to the burner and the Furnace will not operate
with the switch in the OFF position.
o Door models have a power switch located inside of the door.
o Non-door models (LD or Small Vent) have a power switch on the outside of the Furnace.
A. Turning On the Furnace
• Turn the thermostat to the lowest setting.
• Turn OFF all power to the Furnace at the main power supply.
• At the exterior access panel, turn the switch on the Furnace to the OFF position.
• Wait five minutes, then check for a gas odor.
• If a gas odor exists around the Furnace or floor area, follow the instructions in the warning box on the cover
page.
• If no gas odor is present, proceed to the next step.
• At the exterior access panel, turn the switch on the Furnace to the ON position.
• Turn ON the main power supply.
• Set the thermostat to the desired temperature.