Congratulations on the purchase of your new G3 Aluminium Wheelchair.
Equipped with several features and accessory choices you are sure to enjoy
the benefits of this chair.
Please follow these simple steps to assemble your wheelchair –
1. With the chair upright, push down on the sides of the seat until it
clamps into position.
2. Lift backrest up to click into position. Depress black latch to fold.
3. Fit legrests (both left and right) into the fitting from an outward angle
and turning inward until it locks into position. Footplate height can
be adjusted using the allen key provided
.
Loosen the footplate and
select the desired height, retighten to secure
.
Elevating legrest are
available for this chair and fit into place the same way as the
standard legrests. To adjust loosen the screw, select the desired
angle and retighten.
4. G3 Self Propel Wheelchairs have a quick release 24” wheel. To
release push the centre button on the axle and pull out. To reinstate
locate the axle back into bracket on the frame. Ensure it is fully
engaged before using the chair.
5. Armrests flip back and are removeable. To release the armrest push
the clip at the front and flip back, to re-instate clip back into the front
bracket and ensure it locks into place. To remove armrest push clip at
the front and pull lever at the rear then lift armrest up armrest.
Again ensure clipped back in securely when replacing.
6. Care-assist hand brake , (where fitted) provides added security to the
person pushing the chair. When the wheelchair is stationary, the
hand brake at the wheel should be applied for added security. To
apply push forward, to release pull back.
Assembly / Adjustment
