Aurora AU 3545, Manual

Page: 3 / 9

AU
3545 ENG
3
Electric shavEr
Carefully read these instructions before operat-
ing to prevent damage during use.
Improper handling may damage the product,
property damage or harm the user’s health.
The product is intended for household use only.
do not use this product for industrial or commer-
cial purposes.
Use only at home. The device is not designed for
industrial and commercial use.
Before the first charging the battery, make sure
that the voltage in the electrical supply corre-
sponds to the voltage of the product.
Use an electric shaver only for its intended pur-
pose. do not leave the product unattended.
Continuous operation time should be no more
than 10 minutes with a mandatory break of at
least 10 minutes.
do not leave the product in places with high hu-
midity and temperature.
Charging should take place at a temperature from
0 ° C to + 35 ° C and a relative humidity of 80%.
To recharge the electric shaver, use the power cord
that comes with the kit. do not use the power cord
if damaged insulation and forks.
When the product is disconnected from the mains,
do not pull the cord, hold the plug by hand.
do not disassemble or repair the product. for
repairs, please contact your nearest authorized
service center.
The product is not intended for use by persons
(including children) with reduced physical, sen-
sory or mental capabilities, as well as if they have
no experience or knowledge, unless they are
controlled or are not instructed on the use of the
appliance by a person responsible for their safety.
Children must be controlled to prevent the game
with the product.
do not leave the product in direct sunlight.
ATTENTION! razor blades are very sharp and can be
dangerous. Use them with extreme caution!
do not place the power cord near hot surfaces or
near open flames.
do not immerse the shaver, the power cord and
the plug in water or any other liquid.
ATTENTION! do not let children play with plastic
bags or packaging film. risk of suffocation!
ATTENTION! The shaving foil is very delicate. With im-
proper use, it can be damaged. To avoid injury, do
not use the shaver if it has a damaged foil or a knife.
If the product was a time when temperature be-
low 0ºC, before switching it should be kept in the
room for at least 2 hours.
SAFETY PRECAUTIONS
CHARGE SHEET
1. Connect the power cord to the shaver, and
plug the power cord into an AC outlet. In this
case, the lamp lights up the charge.
2. fully charging the shaver is 8 hours.
3. If the shaver regularly charging more than 10
hours, it reduces the capacity of the battery.
4. do not use the shaver while charging.
WORK
1. remove the protective cap.
2. switch the shaver for this, turn the switch to the
top position.
3. during shaving razor hold the right angle (90°)
to the skin.
4. After finishing shaving razor off, turn the switch
in the down position.
5. To prevent damage to the shaver foil and cut-
ter every time they close the protective cap when
you do not use a shaver blade or during trans-
port.
CAUTION! excessive pressure of the shaver to
the skin during use does not increase the shav-
ing performance and can cause damage to the
shaver foil.
BEFORE USE