Aurora AU 3029, Manual

Page: 10 / 12

AU
3029
Steam station iron
ENG
10
WORK
Install the appliance on a flat, stable, heat-and
moisture-resistant surface so that it is flush with
your ironing board. Connect the equipment into
an outlet.
Heating indicator lights. Set the required ironing
temperature. When indicator light goes out, you
can start ironing.
If you set the temperature lower than that at
which you ironed, it is not recommended to start
ironing again until indicator lights.
FILLING WATER TANK
Before filling tank water unplug the appliance.
Filling the water tank is performed using a funnel.
To prevent overflow, do not pour water above the
mark.
If you want to add water in the process of ironing,
first unplug the appliance.
TEMPERATURE SETTING IRONING
Before starting work, refer to the instructions for
ironing specific tissue type.
Choose the product composition of fiber de-
pending on the ironing temperature: wool to
wool, cotton to cotton, etc.
Heating iron is faster than cooling. So start iron-
ing products requiring lower temperature, and
then proceed to the following products.
If the fabric consists of various kinds of fibers, you
need to start the process of ironing with the low-
est required temperature. For example, in the ma-
terial contains 60 % polyester and 40 % cotton,
you need to select the temperature for polyester.
Turn the temperature control to the position in
accordance with the type of fabric you are going
to be ironed.
BODY POSITION
Ironed, keeping your back straight.
Set the height of the ironing board so that the
iron handle is level with the elbow.
When properly selected temperature is not nec-
essary to apply pressure to the iron.
The best results are achieved when the laundry
is low wet.
STEAMING
Place the iron on the stand.
Make sure that enough water in the reservoir.
Connect the device to the mains. The indicator
lights.
With the thermostat to set the desired tempera-
ture for ironing on «••» in the «MAX».
Switch to set the amount steam supply. When in-
dicator light goes out, you can start ironing.
DRY IRON
To do this, you must turn off steam supply switch,
and do not press intensive steaming.
You may ironing in a dry mode, even if the tank is
filled with water.
However, when a long working in this mode are
not to be poured into the reservoir of a lot of water.
STEAM BLOW
This function is used for additional single steam
supply when ironing very rumpled places.
Make sure that enough water the reservoir.
Set the thermostat to the position of «••» in MAX.
During ironing press steam supply.