Aurora AU 193, Manual, Page: 11 / 12

SELF CLEANING
Fill the water tank to the maximum label, then close the lid.
Set the thermostat at maximum position.
Connect the unit to yelektromerezhi.
Wait until the indicator turns off heat.
Hold the iron horizontally over a sink, install a steam regulator in the maximum position and press the
steam.
Steam and boiling water, based on the nozzle, remove zabrudzhennya. It should shake the unit forward
and backward.
With strong zabrudzhenni iron self-cleaning cycle should be repeated.
To dry the sole piece of junk poprasuyte tissue.
FINISHED IRONING
Set the iron on its heel.
Set the dial to “MIN.”
Unplug the iron from the mains.
Let it cool.
You can follow any responses to wind the cord.
Keep the iron in an upright position to avoid damaging the work surface.
PLEASE NOTE:
At the end of work is always necessary to completely remove water from the tank.
CLEANING AND MAINTENANCE
STORAGE
SPECIFICATIONS
Before cleaning the appliance, make sure that the iron is unplugged and completely cooled. Clean the
housing with a damp cloth, then wipe dry. To clean the soles can not use abrasive cleaners.
Unplug the appliance and allow it to cool completely.
Free water tank, and then wrap the cord around the heel.
To protect the work surface from damage, store the unit in an upright position
setting on the heel area.
Power Supply 230 Volt, 50 Hertz
Power 2000 W
AU
193
Праска \ Утюг \ Iron
11
ENG