6
User Guide
OPERATION
Routing
To route a source to a source to a destination(s):
Step 1. Press Input
Step 2. Press desired input number
correlating to the rear of the unit’s HDMI input. If no route is required
then do not press a number. If a number has been pressed and you wish to deselect press the same
number again.
Step 3. Press Output followed the output number(s) correlating to the rear of the unit’s HDMI output(s).
Step 4. Press Route for the selections to take.
EDID
Step 1. Press Output than a number of an Output to select the EDID of the destination to be learned and
saved into an input(s).
Step 2. Press Input followed by the HDMI input number(s) to store the EDID.
Step 3. Press EDID and the information will be stored to the selected inputs.
Note: More advanced EDID functions can be done through the Serial or LAN interface commands.
For EDID Auto press EDID key then the
“1” key. For EDID Manual press EDID key then the “2” key.
Presets
To save a preset:
Step 1. Setup the routing as desired.
Step 2. Press Save.
Step 3. Press desired preset number 1-8 to store the preset.
To recall a preset:
Step 1. Press Recall
Step 2. Press the desired number of the preset location to be recalled.
