TVP-500F Installation Manual
3 Quick Start Guide
1.
Make sure the Pioneer Display is off (no LED) and disconnected from the power.
2.
Remove the blank plate covering the expansion slot or if an existing card is present, it must be
removed from the slot.
3.
Carefully insert the card into the slot and tighten the spring loaded screws.
4.
Connect the appropriate video sources to input connectors of TVP-500F (see “Connections” on
page 4 for details).
5.
Connect the power source to the display (refer to Operating Instructions of the Display).
6.
Turn on the display with the power button on the
display remote.
Warning: Please keep in mind static images can lead to image burn in on some displays. Never leave a
still image on a phosphor based screen for long periods of time unless the intensity of the display is
turned down. Refer to your operations manual for you display device to assure proper functionality.
4 Pioneer Display Settings
Initial settings on the first use of TVP-500F:
Main Menu
Æ
Set Up:
- Color
Decoding: RGB
- Clamp
position:
Locked
- Signal
Format:
525P
Note: Inputs 3 and 4 have Color Decoding only.
Integrator Menu
Æ
Option:
- Baud
Rate:
9600
To get into Integrator Menu, press and hold Display key on the display remote for approximately
5 seconds. Then press Menu key on the display remote. This will bring up the Integrator Menu.
It may be necessary to adjust picture size and position for best picture alignment using Screen adjustment
from the display Menu and from Video Position on TVP-500F Menu (page 9).
Plasma Displays often "overscan" the image slightly; in some cases when displaying a channel, there
may be a narrow black bar on the left/right or top/bottom of the screen. Use the utilities mentioned above
to “overscan” the picture as necessary to ensure that picture is filled the entire screen for all channels
and signal inputs.
3