~ 6 ~
1.
Connect VGA source to the video input with a VGA cable.
2.
Connect S/PDIF or stereo audio source to RCA jack or 3.5mm earphone jack respectively.
3.
Connect HDMI display to the HDMI output connector with a HDMI cable
4.
Power up the ASP-VTH.
1.
Power up the ASP-VTH. Connect display to HDMI Output.
2.
To learn EDID from HDMI display, pull down the DIP switch 1 to ON [
ª
], the green light will be dark and bright to
indicate the EDID learning process is complete. You DON’T NEED to pull up the DIP switch again unless you want to
learn another EDID by pulling DIP switch 1 up and down.
1.
Only HDMI enabled TV sets with underscan/overscan
*
support, the full active video can be accurately displayed.
Some HDMI equipped TV sets may not support this feature. If underscan/overscan
*
is NOT supported, the top, bottom,
left and right border of the active video may be screened, and the S/PDIF audio may not sound right.
2.
Analog stereo audio can merely support 2-channel audio. This version does NOT support 8-channel analog audio
applications.
3.
S/PDIF audio input supports the main 2-channel audio input
4.
S/PDIF supports only 48kHz audio sample rate. Other than this rate, the input digital audio should be adjusted to
48kHz in order to get audio signal correctly sent.
*
The
underscan
mode
displays
the
full
video
frame,
which
reveals
content
on
the
edge
that
is
recorded.
In
overscan
,
the
field
monitor
zooms
in
to
the
area
that
would
be
visible
on
most
televisions.
Set
the
field
monitor
to
underscan
if
your
video
will
be
viewed
on
a
computer
monitor
or
shown
with
a
projector
and
also
to
look
for
light
stands,
microphones,
and
other
unwanted
objects
on
the
edges
of
your
shot.
Set
it
to
overscan
to
see
how
the
video
will
look
on
a
television.
Hardware Installation
Notice
EDID Learning