Auriol 4-LD5009, Usage And Safety Instructions

Page: 11 / 27

- 9 -
Sunny Downpour
Slightly
cloudy
Rain
Cloudy
Heavy
snowfall
Snow
Barometer
Your weather station can show the air pressure tendency
4
.
Air pressure rising
Air pressure constant
Air pressure falling
You can also select absolute or relative air pressure by pressing the
Relative/Absolute
-button
25
. Rel. or Abs. will appear on the display.
Note: The weather station measures the absolute air pressure. Your local
weather service can supply you with the relative air pressure for your location,
which you can input into the weather station.
To change the relative air pressure, press and hold the
Relative/Absolute
-button
25
for 3 seconds. The air pressure value will blink on the display and can be set
by pressing the
°C/°F +
-button
29
or
MAX/MIN
-button
27.
Confirm your setting
by pressing the
Relative/Absolute
-button
25
.
Select the air pressure unit Hectopascal (hPa) or Inches of mercury (inHg) by
pressing and holding the
°C/°F + -button 29
for 3 seconds.
12-hour air pressure history
Press the
HISTORY/WEATHER
-button
31
to view the air pressure history for the
last 12 hours.
0 – HR = current air pressure
- 1 HR = air pressure 1 hour ago
-2 HR = air pressure 2 hours ago... and so on
Outdoor sensor/channel setting
You can use the weather station with up to 3 outdoor sensors at the same time.
Open the battery compartment of the outdoor sensor
43
and select a channel (1-
3) by using the Channel selection switch
42
. Press and hold the
CHANNEL
-button
33
for 3 seconds or until an audible signal sounds. The weather station will now
attempt to receive the signal
3
.
Now press the
TX
-button
40
to manually transmit the temperature from the outdoor
sensor to the weather station.
Close the battery compartment. Press the
°C/°F
-button
39
to select
°C
-Celsius or
°F
-Fahrenheit.
Note: The outdoor sensor must be within a maximum distance of 100 m of the
weather station with no obstructions.
If you are using mutliple outdoor sensors: Press the
CHANNEL
-button
33
to select
the reception channel.
The rotation symbol on the display at
23
indicates that the weather station is
rotating through channels 1-3.
Only active outdoor sensors are displayed. Press and hold the
CHANNEL
-button
33
to remove unused channels. When adding an additional outdoor sensor, the
weather station will detect it automatically. You can also manually transmit the
signal by pressing the
TX
-button
40.