Manual
Manual
8
9
PAGE 1/5
MIC FEED BACK
6 degrees feedback inhibition, range:-3~+3; OFF; -3~-1 are negative inhibition, +1~+3 are
active inhibition, each degree contains 0.2Hz.
MIC POWEREX
Power Excitation Function of Microphone
GAIN: Power excitation range 0~20; 0 means OFF, users can adjust 1~20 degree, the more
degree it is set, the more obvious effect of excitation users feel.
FREQ: Frequency range: 60Hz~240Hz
PAGE 2/5 COMPRESS SETTINGS
COMP SWITCH
ON/OFF, it is used to switch on/off the function of compressing the dynamic range and tighten
uneven parts of audio signals.
COMP THRSH
Range:-25~+25, it is used to set the signal level at which the compressor starts to work. If the
threshold level is set at -10dB, only signals that pass above -10dB will be compressed; signal
below the level will not be compressed.
COMP RATIO
Range: 1.0~100, it is the amount the unit compresses the signal level and indicates the differe
nce between the signal increase before compression and the increase at the output level. A 2:1
ratio means if the incoming signal is 2dB above threshold, the output signal after compression is
1dB above the threshold.
ATTACK TIME
Range: 0~100ms, it is used to set the time takes for the compressor to starting compressing
when threshold is reached.
RELEASE TIME
Range: Starting time
×
2~ Starting time
×
32, it
defines the time takes for the compressor to
stop after the signal dips below threshold.
PAGE 4/5 MIC1~4 FILTER
HIGH PASS
Range: 20Hz~20000Hz
Preset 8 types of High-pass
filtering: BL_12, BW_12, LK_12, UR_12, BL_24, BW_24,
LK_24, UR_24
Q: UR_12, UR_24 are 0.1~1.3 adjustable, other types are stable.
LOW PASS
Range: 20Hz~20000Hz
Preset 8 types of Low-pass
filtering: BL_12, BW_12, LK_12, UR_12, BL_24, BW_24,
LK_24, UR_24
Q: UR_12, UR_24 are 0.1~1.3 adjustable, other types are stable.
PAGE 5/5
MIC1~4-EQ
ON/OFF, it is the switch for turning on or off the EQ editor.
MIC 1~4 EQ Editor
BAND: 1~12;
FREQ Range: 20Hz~20000Hz;
TYPE: PEQ: Manipulates a set range of frequencies, out in both directions from the center
frequency, with the
“Q” parameter determining the width;
HS Shelf: High-pass Filtering Shelf, manipulates all frequencies above the set frequency;
LS Shelf: Low-pass Filtering Shelf, manipulates all frequencies below the set frequency;
GAIN: -30~+12dB, allows adjusting the gain of the setting frequency band.
Q: 0.1~128, it is used to adjust the width of the PEQ
filter, Lower values, create wider EQ
curves (covering wider a wider range of frequency); higher values create narrower EQ curves
(covering a much smaller range of frequencies for more surgical EQ work);
HS: High-pass Filtering, 0.1~1.3;
LS: Low-pass Filtering, 0.1~1.3;
PAGE 3/5 MIC VOLUME/POL
MIC VOLUME
Range:-40~+6dB, it allows to adjust the volume of MIC 1~4;
MIC POL
0 degree (+), 180 degree (-) adjustable, it allows to adjust the phase of MIC 1~4.
K-5200
Processing & Parameters
K-5200
Processing & Parameters
