6
First start-up of RTH receiver
The first connection of the RTH receiver to the supply network will result in
the receiver going into the "association" mode for 120 seconds. It is
signalled by LED diode flashing with a green light.(see chapter: "Associating
device with RTH receiver" and "RESETTING - Signing out all devices assigned
to receiver).
Note
: The RTH receiver purchased in the set with the temperature controller
already has an associated device and the above case will not take place.
Associating device with RTH receiver
OFF
ON
IN
OUT
ALARM
RESET
LED
In order for the AURATON RTH receiver to operate correctly it must be first
"associated" with one of the system devices (e.g. the AURATON T-1
temperature controller ).
1
.
Associating a new device with the receiver is
initiated by pressing the left association button
(green triangle -
) on the receiver and
pressing it for at least 2 seconds, until the LED
diode starts flashing with a green light, then we
release the button.
Note
:
The receiver is waiting for association for
120 seconds. seconds. After this time it will
automatically return to normal operation.
.
2
.
When the LED diode of the receiver flashes with a green light, press the
"association button" on the device that you want to associate and hold it for
at least 2 seconds (precise association manual is attached to each device).
3
.
Correct completion of association is signaled by the stop of flashing with
a green light of the LED diode on the receiver and the receiver going into
normal operation.
In the case of an error during association, steps 1 and 2 should be repeated. At
subsequent errors, sign out all devices by RESETTING the receiver (see chapter
"RESETTING-Signing out all devices assigned to receiver") and try to associate
the device again.
Note
:
Once added device cannot be again associated with this receiver, since it
is already saved in the receiver memory.
