8
Cabling
The I/O ports on the back of the unit are shown as following:
1
Right Balanced Analog Input
5
Right Balanced Analog Output
2
Right Single-Ended Analog Input
6
Right Single-Ended Analog Output
3 Left
Single-Ended
Analog
Input
7 Left Single-Ended Analog Output
4
Left Balanced Analog Input
8
Left Balanced Analog Output
9
AC Mains Power Cord Socket
Please be sure to power off all units in your system before any cabling job, failed to follow
this instruction may result in permanent damage to the device and void any warranty.
ALWAYS POWER OFF TAURUS BEFORE CABLING!
z
Analog Inputs
The balanced and single-ended analog inputs are individually buffered, however, it is still
strongly recommended to disconnect unused ports to avoid any potential electromagnetic
interference induced by cable.
The sensitivity of both RCA and XLR inputs are same as 2Vrms with a maximum allowed
level at 6Vrms. Please be sure to use a source component with its output level within this
range.
Since the input impedance of the RCA and XLR ports are designed to be very high
(100K@RCA / 200K@ XLR) to capture music details from the source, we recommended
you to use shielded interconnect cable to avoid noise pick-up from the environment.