17
Phono Settings
•
Anti Skating:
Use the anti skating knob to adjust the pressure of the needle.
•
Platter speed alignment:
While playing a vinyl record, observe the appropriate strip of strobe calib
-
ration dots from the strobe lens. The upper one is for 33RPM, the middle one is for 45RPM. If the stobe
dots appear to float to the right, the platter rotates too slow for the record. Adjust the pitch control to
fine tune (+). If the dots seem to float left, slightly turn the pitch control down (-).
•
Adjusting the Auto-Stop position:
If the system does not completely play the record, but returns the
pickup arm too early, rotate the alignment screw (22) clockwise. If the player does not return the pickup
arm automatically, rotate the screw anti clockwise.
Please note: The default setting is based on the most common template; if you adjust it, please check
the return position time by time during adjustment, and avoid over tunding the screw. Ask someone
experienced, when in doubt. Only turn the screw in steps of 1/4 turns to be safe. Breaking the thread
can cause defect to the record player - in this case the warranty expires.
Radio
Press the power button to switch on the unit and select the function switch (20) to TUNER position
•
Manual tuning
•
Select the desired band by radio band selector (fm or fm-stereo).
•
Tune to the required station by turning the tuning knob.
•
Adjust volume knob to the desire volume level.
•
FM & FM-stereo reception
•
Set the radio band selector at “FM” position. Programs are received in mono mode. In particular
when stereo signal are weak. It is preferable to receive the program in mono.
•
Set the radio band selector at “FM-St” position for receiving stereo programs. The fm-stereo led
indicator will light up to show fm stereo program is receiving.
•
The receiver has a built-in fm wire antenna hanging at the rear cabinet. This wire should be totally
unraveled and extended for best reception.
CD
•
Switch the Function selector to SOURCE (20), then select CD mode (12).
•
Press “Open/Close” to open the CD door. Place a CD with the printed side facing up inside the tray
& then close the CD door. Focus search is performing, the LCD display will show the total number of
tracks & total playing time.
•
Convenientliy use
/
as well as PLAY/PAUSE and STOP to navigate.
•
Repeatedly press
REPEAT
for REPEAT 1 - REPEAT ALL - REPEAT OFF