- 06 -
Video Recording
●
Loop Recording: Recording will begin automatically after powering on with a micro
SD card in the device. Each recorded file is up to ten minutes long, with old footage
being replaced when micro SD card storage is full.
●
Motion Detection Recording: Switch on motion detection in ‘Setup.’ This function will
start recording video when the dash camera detects motion in front and stop recording
when motion is no longer detected.
●
Time-Lapse Recording: Switch on time-lapse recording in ‘Setup.’ This function will
capture a picture per second to make a video played at the same number of frames
per second as the current recording resolution setting.
Emergency Recording
●
Manual File Backup
Press to back up the current file so that it will not be overwritten. A icon will
appear in the top left of the LCD screen to indicate a protected emergency recording
is in progress.
●
Auto File Backup
Once the G-sensor is activated by a sudden impact, the device will automatically
make a recording and protect it from being overwritten. Adjust G-sensor sensitivity in
the ‘Setup’ menu.
Snapshot
●
Hold down for 3 seconds to take a snapshot while in recording mode
●
The snapshot files are located in the \ AUKEY\PHOTO folder on the micro SD card
●
The icon will be shown after you take a snapshot. This will not interrupt the video
recording
Audio Recording
Turn on/off audio recording by long-pressing when in recording mode (or by
adjusting in ‘Setup’ menu). When audio recording is on, in-car audio will be recorded
during video recording. Voicing details of possible hazards that may develop,
especially when off-camera, may provide useful information. You can even use it to
record car license plate numbers that may not be captured on the video.
