User Manual smar-tel-i
55
Progr
am
mi
ng
Using the Call-Screening function, you can reject (or accept) incoming calls from selected
subscribers, assuming that these subscribers transmit their telephone numbers. A
maximum of five screened numbers can be entered. These may then all be blocked (smar-
tel-i can not be reached by these callers) or they may all be accepted (smar-tel-i can only
be reached by calls from these subscribers.
The filter can be deactivated without having to delete the filter numbers. If the call-screening
function is activated, the middle LED signals green and the display shows the symbol
@
(fil-
ter action accept) or
}
(filter action reject).
Example: Install the filter number “030 87654321“ as “filter action reject,“ so that
smar-tel-i does not ring when this number is calling.
h
The area code must always be entered as well, otherwise the telephone number can
not be recognized due to technical reasons.
In some cases when operating a PBX, the exchange access code must also be
entered. You can determine whether this is required in your case by reading the chap-
ter Alternatives for Initiating Exchange Line Access on page 35.
5. 7. 2
Screening calls
Search for the function under the menu-group
SETTINGS
(refer to page 31).
change
A
Open the menu.
change
A
Initiate entering the filter number.
r
Enter the first filter number with the area
code.
(Inputting Numbers: refer to page 32).
ok
A
Store the filter number.
ok
A
Terminate the enter mode.
block
A
Press the soft-key under “block“ so that ringing
is blocked for incoming calls of the number
entered.
(If your smar-tel-i is to ring only when this num-
ber calls, then press the soft-key under
“allow“).
ok
A
Store the settings.
Call Screen OFF
change next
S1
ok change
S1:_
ok del
S1:03087654321_
ok del
S2
ok change
Call Screen OFF
ok allow block
Call Screen blocked
ok allow off
