Auerswald COMmander Basic.2, Installation And Commissioning Instructions

Page: 60 / 84

Commissioning
60
– The USB cable included in the delivery.
Steps to Take
1.
Insert the square USB cable connector into the USB
socket on the PBX.
2.
Close the PBX casing.
3.
Turn the PBX and the PC on.
4.
Insert the flat connector on one end of the USB cable
into a USB port on the computer.
Further Steps
쑱
Install the RNDIS driver for the device. See Page 60
for Windows XP.
Installing the RNDIS Driver on Windows XP
Requirements
– Auerswald Mega Disk (as of version 5.81)
Steps to Take
The hardware wizard will automatically start in
order to install the RNDIS driver for the device.
1.
Click No, not this time, and then click Next.
2.
Insert the Auerswald Mega Disk into the CD-ROM
drive.
3.
Click Install the software automatically
(Recommended), and then click Next.
A search is made for the driver to be installed. As
soon as the driver is found, you are asked
whether you would like to continue.
4.
If necessary, click Continue anyway.
The installation of the driver is resumed.
5.
Click Finish.
Putting Analogue End Devises into Operation
Requirements
– The internal phone number configured on the a/b port
in question
– Earthed PBX (see Page 30 and Page 38 )
Steps to Take
1.
Connect end devices with a separate power supply to
the 230 V mains.
The end device is ready for operation.
Putting ISDN System Telephones into Operation
Requirements
– The internal phone number configured on the S
0
port
in question
– Earthed PBX (see Page 30 and Page 38 )
Steps to Take
1.
Connect end devices with a separate power supply to
the 230 V mains.
2.
Select the language.
3.
Enter the internal phone number as an MSN for the
end device.
The end device is ready for operation.