43
Digital domain
ADVANCED MANUAL / TH uno
UP
DOWN
UP
DOWN
DOWN
UP
UP
DOWN
MENU
ENTER
BRIDGE
0 180
PHASE
MASTER
CHAIN
PUSH
LEVEL
0.3 ÷ 1.2V RMS
1.2 ÷ 4.8V RMS
Hi :
Lo :
TH uno
ASC - Amplifier Status Controller
Setup Amplifier: Amp ID
AMP ID stands for Amplifier IDentification. The AMP ID is a way to identify the task the amplifier performs inside
the system. The AMP ID does not affect the electric functioning and does not act on the amplifier electronic
crossover. The AMP ID is fundamental to adjust Volume, Balance, Fader as well as Sub Volume when the DRC
is connected. The ASC recognises the function the amplifier has been given through the ID. By acting on the
DRC and adjusting Volume, Balance, Fader as well as Sub Volume, as a consequence also the signal to the
amplifiers will be managed.
Example:
If the AMP ID-Front is assigned to the TH amplifier, by operating on the DRC its general volume, as well as the
right/left balance, will change. Also, by setting the Fader on Rear you will hear the volume diminishing;
however, no change will be perceived if you operate on the DRC Sub volume.
Vice versa, if the AMP ID – Subwoofer is assigned to the TH amplifier, by operating on the DRC its general
volume, more specifically the Sub volume, will change; however, no change will be perceived if you operate on
the right/left balance or moving the Fader.
In order to avoid errors, you should assign the ID according to the speakers connected to the amplifier.
Default Entries
PRESS ENTER TO CONFIRM YOUR
SELECTION AND MOVE TO THE
NEXT SETUP
PRESS
ENTER TO
REACH
