UNDER CABINET INSTALLATION
1) Choose an appropriate mounting location underneath a cabinet or shelf. Close proximity to an electrical
outlet and a TV antenna or cable connection will facilitate a neat, easy installation. Do not mount the VE706
above a range or oven. Be sure that the location chosen will provide adequate access to the electrical
connection on the rear of the unit before continuing.
2) If the location chosen has a bottom edge molding it may be necessary to use the mounting spacers
provided to effectively lower the VE706 below or even with the molding. Measure the distance between the
edge molding and the bottom of the cabinet. The spacers and mounting holes are stepped to achieve
different mounting heights from .5” to 1”. Adjusting the mounting height is done by lifting and rotating the
spacer in the mounting hole. Choose a spacer height, which will allow the VE706 to clear the edge molding.
3) Measure the thickness of the bottom of the cabinet or shelf and the spacer height chosen. Select the
shortest screw length, which will secure the VE706 to the bottom of the cabinet.
4) Cut out the template supplied and tape it in place onto the cabinet surface to be drilled. Center punch the
four holes indicated on the template and remove the template.
5) Carefully drill four 1/8
″
holes at the locations marked above. Place the screws selected through the VE706
and then through the spacers (if required from the bottom-up)
6) Connect your TV antenna or cable system to the antenna connector on the rear of the VE706.
7) Attach the FM Dipole Antenna and position the antenna for the best reception.
8)
Attach the AM Antenna and position the antenna for the best reception.
9) Position the VE706 and mount it in place using the selected screws.
(Note: Do not over-tighten.)
8
10) Plug the AC power cable into the wall outlet. Route the wires safely away from heat and moisture sources.
