Note
If the changer is to be installed in a car that is equipped with an on-board drive or navigation computer, do not disconnect
the battery cable. If the cable is disconnected, the computer memory may be lost. Under these conditions, use extra caution
during installation, not to cause a short circuit.
Do not install the unit in the following locations.
Locations exposed to direct sunlight.
Where hot air is discharged from the car heater.
When proper installation is not possible and where a great deal of vibration is generated.
Be sure to use the supplied brackets and screws.
Be careful not to snag any wires when tightening screws and installing the ground wire.
When installing the unit, do not use any screws that are part of the brake or steering system.
This unit cannot be installed in any way except that which is authorized (on its side, on its end, at a 45° angle or suspended).
BEFORE INSTALLING THE UNIT
Transport lock screws
The mechanism in the CD changer is "locked" into place during shipment by the
transport screws. Be sure to remove the screws prior to installation.
After removing the transport lock screws, place the supplied seals over the screw
holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
Installation and Wiring Precautions
To prevent a short-circuit,
Be sure to turn off the ignition and remove the negative (-) battery cable, prior to installation.
Connect power wires last.
1
2
4
3
2
Caution
ID (Identity) Switch for 2nd CD Changer
By using the separately sold Divider unit, an additional compatible CD changer can be installed. When an additional CD changer has been
attached in this fashion, the ID switch is used to indicate the number of each respective changer unit.
When changer is used independently.
* The ID switch is initially set to "1" when shipped.
When changer is used as additional changer unit
* Use a ballpoint pen or similar fine-tipped implement to
change the orientation of the switch.
2nd unit (additional
changer unit)