Page 5
ELIMINATING THE NORMAL ARM / DISARM CHIRPS
As explained earlier in the manual, you can eliminate the chirps selectively any time you
arm or disarm the system simply by holding the Lock/"Arm" / Unlock/"Disarm" button for
two seconds. If you find the normal arming and disarming chirps annoying, they can be
turned off permanently, eliminating the need to hold the Lock/"Arm" / Unlock/"Disarm"
button for two seconds.
To do this,
1. Start with the valet switch in the off position, then turn the ignition key on
then off.
2. Within 10 seconds, move the valet switch to on then off three times.
3. If the chirps were on before you started, then you will hear 2 chirps indicating
they have been turned off.
If the chirps were off before you started, then you will hear one chirp indicating
they have been turned on.
NOTE:
If the siren/horn chirps two times, regardless of the valet switch operation as
described above, then the horn and siren chirps have been turned off via
programming features 7 & 8. Contact your installation center or Audiovox
technical department for information on how to reinstate the chirp feature through
programming.
NOTE:
Whenever the chirps are by - passed, the 4 chirp intrusion indicator and 3 chirp
defective zone indicator will always operate. Since these are important warnings
to you that something has happened, they cannot be eliminated.
REMOTE PANIC OPERATION
The Lock/"Arm" / Unlock/"Disarm" button on your keychain transmitter also functions as a
panic switch for use in emergency situations. To use remote panic,
1. Press and hold the Lock/"Arm" / Unlock/"Disarm" button on the keychain
transmitter for 3 or more seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the Lock/"Arm" / Unlock/"Disarm" button on
the transmitter again for 3 seconds. If the button is not pressed, the alarm will
automatically stop after 30 seconds.
NOTE :
All normal transmitter functions will operate in the panic mode.
REMOTE TRUNK RELEASE ( CHANNEL 2 )
This security system is equipped with an on board trunk release relay which will activate
the existing factory installed electronic trunk release mechanism. If your vehicle is not
equipped with an electronic trunk release mechanism, this feature may have been con-
nected to another accessory. Please ask your dealer for further information.
To remotely open the trunk, press and hold button 2 on the keychain transmitter for
four seconds.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 3 )
This security system has an additional feature that can be connected to a number of differ-
ent optional accessories. Some of the more common uses for this channel are;
Remote Car Starter
Remote Window Closure
Remote Garage Door Interface
To activate the optional accessory, press both buttons on the keychain transmitter
simultaneously. The optional accessory will immediately engage.
