Audiovox Pursuit PRO 9232S Owner'S Manual Download Page 7

NOTE:

If 15 seconds of inactivity expire, or if the ignition switch
is turned off for more then 5 seconds during any of the above steps,
the unit will revert back to the last success fully stored code.

ADDITIONAL REMOTE FUNCTION:

This system allows the control of any one of the following optional accessories;

Remote Car Starter
Remote Window Closure
Remote Window Open

To operate the optional accessory;

1.

Press the lock, then unlock, then lock buttons on your keychain transmit
ter within 3 seconds.

2.

The optional accessory will immediately activate.

OPTIONAL AUTO LOCK/UNLOCK FEATURE:

If your existing factory installed keyless entry system did not include the automatic
door lock and unlock feature, then this feature can be activated from the PRO 9232
upgrade module.  When this accessory has been added, any time the ignition key
is turned to the on position 

and all vehicle doors are closed, the doors will lock

in 4 seconds.  Additionally, any time the ignition key is turned to the off position,
the doors will unlock.

ELIMINATING THE ARM/DISARM CHIRPS:

The normal arming and disarming confirmation chirps can easily be turned
 off using the valet pushbutton switch. To do this:

1.

Turn the ignition key on, and then off.

2.

Within 10 seconds of turning the ignition key off,press and release the
valet  switch 3 times.

3.

a.

If, before proceeding with step 1, the chirps were on, then you will
hear  2 chirps to indicate that  the chirps have been turned off.

b

If, before proceeding with step 1, the chirps were off, then you will
hear 1 chirp to indicate that the chirps have been turned on.

4.

Whenever power to the system has been disconnected ( for repair or
service to the vehicle ), the chirps will be activated when the power is
re - connected. To turn the chirps off, simply execute steps 1 through
3 above.

NOTE : Whenever the Arm/Disarm chirps are by-passed, the 3 chirp defective

zone and the 4  chirp intrusion indicator will always operate. This
feature will always warn you if a door was left ajar when arming, or the
vehicle was tampered with in your absence.

Summary of Contents for Pursuit PRO 9232S









Reviews: