128-8856b
2 of 4
2
REMOTE STARTING THE VEHICLE
This will not start the vehicle if any one of the following situations
exists:
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1. To start the vehicle, press and release the
transmitter button two times within 2 seconds.
The vehicle will start and remain running for the
pre-programmed time of up to 60 a minute run
cycle. As a visual indication, the parking lights
will flash or remain on depending on the setting
by your installation center. Additionally if the two way trans-
ceiver, shown right, is used, the transceiver will play a melody
when the vehicle is started, and the Orange LED surrounding the button will
flash every ten seconds while the vehicle is running.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the
spring loaded start position), then step on the brake pedal to disengage the
remote starter. The vehicle will continue to run, but now on its own power.
NOTE:
The engine will stop running before the pre-programmed run cycle
has expired if you perform any one of the following functions:
Press and the button on the keychain transmitter two times within 2 seconds
Depress the brake pedal
Open the vehicle's hood
Place the unit in the safety control disabled mode.
PUSH-BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY CONTROLSWITCH
The Push-Button LED switch located in the receiver allows you to temporarily
disable the remote starting function of the system. This is recommended when-
ever the vehicle is being serviced. To place the system in the service mode:
1. With the system disarmed/unlocked, and the ignition switch off, press and
hold the Push-Button, found on the windsheild receiver.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED begins to flash two short flashes followed by one long flashes and
continues this pattern until returned to normal mode of operation.
This puts the unit into the R/S Override mode indicating that the remote start
is in the service mode and will not start from RF or any other input Posse
or otherwise.
To Exit R/S Override Mode:
1. With the system disarmed, press and hold the Push-Button, found on the
windsheild receiver, in.
2. Turn the ignition switch on, off, on, off, on, off.
3. The LED turns off indicating that the R/S unit is fully functional once again.