128-7762
3 of 19
To exit program mode, turn ignition off, or press and release valet switch.
RF Programmable Features Bank 3 Is Remote Start Selectable Features:
Feature Selection
1 Chirp
2 Chirps
3 Chirps
4 Chirps
5 Chirps
6 Chirps
1st Defrost Output
Not Available
2nd RF Start Chirp
Not Available
3rd Run Time
5 Mins
10 Mins
15 Mins
20 Mins
4th Parking Lights
On Steady
Flashing
5th Input Check
Voltage
Tach
DBI Input
6th Voltage Level
>0.5V B4 Start
< 0.5V B4 Start
7th Ign. 2 Select
Off During Crank
On During Crank
Same As Accy.
8th Ign. 3 Select
Not Available
9th Diagnostics
Off
On
10th Crank Time
0.8 Sec
1.0 Sec
1.5 Sec
2.0 Sec
11th Gas/Diesel
Gas
Diesel 10
Diesel 15
Diesel 20
12th Transponder O/P
While R/S On
During Start
Until Ign. Off
13th Temp Start
Not Available
14th Crank Averaging
Averaging
Preset Time
Note:
When averaging, the engine must be started 4 times with the key to be effective.
15th R/S Shock
Not Available
16th Turbo Select
Not Available
17th Black/Blue (Aux O/P)
Single Pulse
As Feature #1Bank 2
Note: When setting feature #17 to operate as feature #1 Bank 1 the transmitter will also control this output only while running under R/S command. So in
other words, if this output is used to unlock the doors with the transmitter, the doors will unlock on startup. To relock the doors, use the After Start Black
Green wire of the 4 pin connector.
When using the RF programmer, enter the program mode as follows:
Turn the ignition on
Press and release valet switch 3 times
turn ignition off then on
Press and hold valet switch for 5 seconds
Siren chirps 2 times indicating access to RF feature program mode.
To exit program mode, turn ignition off, or press and release valet switch.
