background image

PROGRAMMING THE TRANSMITTERS

It is important to remember that during programming, each individual step of the
procedure must be executed within 15 seconds of the previous step.
When the 15 second time limit is allowed to expire, the system will automatically
terminate the programming mode. This is indicated by a long chirp from the siren.
Additionally, the system will store codes from up to four  different   transmitters.
If a 5th  transmitter is programmed to any receiver channel, then the first
transmitter programmed to that channel will  be erased from the system's
memory.
To Program replacement or additional transmitters:

1. Enter the vehicle, and turn the ignition key to the "on" position.
2. Press and release the valet push-button switch 3 times.
3. The dash LED will flash one time, and the sounding device will beep one

time, indicating the system is ready to accept programming for receiver's
Lock channel 1.

4. Press and hold the Lock transmitter button until the sounding device emits

a long beep, indicating the signal has been stored into memory.

5. If you have additional transmitters (up to 4) that need to be programmed,

repeat step 4 for each transmitter.

6. Press and release the valet push-button switch once.
7. The dash LED will flash two times, and the sounding device will beep two

times, indicating the system is ready to accept programming for receiver's
Unlock channel 2.

8. Press and hold the Unlock transmitter button until the sounding device emits

a long beep, indicating the signal has been stored into memory.

9. If you have additional transmitters (up to 4) that need to be programmed,

repeat step 8 for each transmitter.

10. Press and release the valet push-button switch once.
11. The dash LED will flash three times, and the sounding device will beep three

times, indicating the system is ready to accept programming for receiver's
channel 3.

12. Press and hold the selected Option transmitter button until the sounding

device emits a long beep, indicating the signal has been stored into memory.

13. If you have additional transmitters (up to 4) that need to be programmed,

repeat step 12 for each transmitter.

14. Press and release the valet push-button switch once.
15. The dash LED will flash four times, and the sounding device will beep four

times, indicating the system is ready to accept programming for receiver's
channel 4.

Reviews: