1. If the L.E.D. is flashing one time...pause...one time... etc., then an intrusion attempt was
made to an optional sensor that has been connected to zone 1.
2. If the L.E.D. is flashing two times...pause...two times...etc., then an intrusion attempt was
made to
a voltage sensing, light activated entry point, or
to the hood, trunk, or an optional
sensor that has been connected to zone 2.
3. If the L.E.D. is flashing three times...pause...three times...etc., then an intrusion attempt was
made through one of the vehicle's doors.
These intrusion warning indicators are stored in the system's memory, and will only be erased
from memory when the ignition key is turned on.
VALET / SYSTEM OVERRIDE SWITCH:
The "Valet" switch allows you to temporarily bypass all alarm functions, eliminating the need
to hand your transmitter to parking attendants or garage mechanics. When the system is in valet
mode,allalarmfunctionsarebypassed,however,theremotepanicfeatureandremotedoorlocks
(optional) will remain operational. To use the valet mode;
1. Enter the vehicle and turn the ignition key to the "on" position.
2. Move the valet toggle switch to the "on" position. The dash mounted L.E.D. will turn on
solid, and remain on as long as the system is in the valet mode.
3. Toreturntonormaloperation,movethevaletswitchtothe"off"positionanytimetheignition
is on.
In the event you lose your keychain transmitter, or if the transmitter fails to disarm the
system, the valet switch can be used as a system override switch. Open the car door (the
alarm
will
sound). Turn the ignition key on, and move the valet switch to the "on" position.
The alarm will stop sounding, and the vehicle can now be started.
NOTE:
Always remember to move the Valet Switch back to the "off" position. This will
ensure that the vehicle remains protected at all times.
ELIMINATING THE ARM / DISARM CHIRPS :
There are two ways of eliminating the normal arming and disarming chirps, and the method that
you choose will depend upon your personal preferences.
Ifyouprefertousethechirpsundernormaloperation,butfindthechirpstobeannoyingincertain
situations, then you can selectively eliminate the chirps in these situations. To do this, simply
hold the transmitter button for one full second when arming or disarming. All functions
explained in the arming and disarming sections of this manual will occur, with the exception
that the chirps will be silent for that transmission.
Page 4