1. Make sure the front panel is oriented correctly when sliding it into the front mounting plate, as it cannot be attached when up-side
down. Use moderate pressure to fully seat the panel into position.
2. To verify correct panel installation, swing the panel assembly up into position until it locks easily into place. If any resistance is
encountered, re-check panel orientation in chassis mounting plate.
NOTE: When the faceplate is in the upright position, press the release button to lower the faceplate away from the radio chassis.
3. When taking the front panel with you, please use the supplied carrying case to protect the panel from dirt and damage. Make sure
there is no dust or dirt on the electrical terminals on the back of the panel as this could cause intermittent operation or other
malfunctions.
NOTES ON USE OF FRONT PANEL
-11-
1. Switch the vehicle ignition and radio “on”.
2. Press and release the Time/Frequency button to access the time display; then press and hold the T/F button until the time
colon begins to flash.
3. With the time colon flashing, press the Down Tuning (
) button to adjust the hours and AM/PM indication, or the Up
Tuning (
) button to adjust the minutes indication to the correct time.
4. Five seconds after the last hour or minute adjustment is made, the time will be set into the unit and the display will return to
the normal indication.
SETTING THE CLOCK
CD SLOT
CD EJECT
BUTTON
FRONT PANEL
MOUNTING
PLATE GUIDE (2)
PANEL MOUNTING
PLATE
FRONT PANEL
RELEASE BUTTON
FACE PLATE
RELEASE BUTTON