cr
MODE SELECTOR (MODE)
This button is used to select the radio, or the playback mode for
the CD player or remote CD changer (if installed). Each press
of the button will select a different mode as indicated on the
display panel.
During CD player operation, this button may be used to change
to radio or remote CD changer mode ("CDC") without ejecting
the disc (the
IN indication will remain on the display panel
to show that a disc is still loaded in the unit). Press the button
again to return to integral CD player mode and resume play of the
disc from the point at which it was stopped.
cs
&
ct
DISC SELECT (CD+ & CD-)
These buttons are used to increase or decrease selection of
a desired disc for play in the remote CD changer. To advance to
a higher number disc, press the "CD+" button
cs
. To return to a
lower number disc, press the "CD-" button
ct
. The number of
the disc in play will be shown on the display panel.
cu
FRONT PANEL RELEASE BUTTON
This button is used to release the mechanism that holds the front
panel to the chassis. To detach the front panel, press the button
so that the left side of the panel is released. Grasp the released
side and pull it off of the chassis.
To re-attach the panel, position the right side of the panel in place
first and then press the left side of the panel until the mechanism
locks it into place.
dl
THEFT-DETERRENT L.E.D.
The theft-deterrent Light Emitting Diode (L.E.D.) is located behind
the front panel and is accessible when the front panel is removed.
The flashing light serves as a visual warning to the would-be thief
that the unit has been disabled by removal of the front panel.
dm
RESET BUTTON
A "RESET" button is located on the front of the chassis (front
panel must be removed to access the button). The "RESET"
circuitry is provided to protect the microprocessor circuitry and
should only be activated under the following circumstances as it
will erase the time and pre-set memories:
1.Upon initial installation after all wiring is completed.
2.After the position of the frequency step switch on the bottom
of the chassis has been changed.
3.If there is a malfunction of any of the switches on the unit,
pressing the "RESET" button may clear the system and return
to normal operation.
-8-
