-3-
appears on the display panel. Within 5 seconds of choosing the
Fader mode, press the + or the - side of the Level Control
2
to
adjust the front-rear speaker levels as desired. When the level
of the front and rear speakers is equal, "0-0" will be shown on the
display panel. Adjusting the fader toward the front speakers will
increase the number on the right side of the display to a maxi-
mum of “0-9” (full front). Adjusting the fader toward the rear
speakers will increase the number on the left side of the display
to a maximum of “9-0” (full rear). The display will automatically
return to the normal indication 5 seconds after the last fader
adjustment or when another function is activated.
9
AM/FM BAND SELECTOR (BND)
AUTO-STORE TUNING (AS)
During radio operation, each momentary press of this button will
change the radio band. The indication “AM”, “FMI”, or “FMII” will
appear on the display panel according to your selection.
Pressing and holding the button for longer than 2 seconds will
activate the Auto-Store Tuning function which will automatically
scan the AM or FMII bands and enter strong stations into the
pre-set memory positions for that band. If you have already set
the pre-set memories on the AM or FMII bands to your favorite
stations, activating the Auto-Store feature will erase those stations
and enter new ones. This feature is most useful when travelling
in a new area where you are not familiar with the local stations.
bl
MANUAL UP/DOWN TUNING (TUN+ / TUN-)
AUTOMATIC SEEK TUNING
Each time the + side of the button is tapped, the radio will tune
one frequency step higher. Similarly, each tap of the - side of the
button will tune one frequency step lower. To manually tune in a
station, tap the button of the appropriate direction until the
desired frequency is reached.
Pressing either side of the button for longer than 0.5 seconds
and then releasing will activate the Automatic Seek Tuning
function in the selected direction. The radio will seek the next
available station and stop at that frequency. The Seek function
can be stopped by pressing the button again or activating any
other tuning function.
Pressing either side of the button for longer than 0.5 seconds will
cause the radio to continue tuning rapidly in the selected direction
until the button is released, at which point it will seek to the next
available station.
bm
LOCAL/DISTANT SELECTOR (LO/DX)
This feature is used to select the strength of the signals at which
the radio will stop during Automatic Seek Tuning. Pressing and
holding the button for two seconds will select the Local setting (“LOC”
will appear on the display panel) and only strong (local) stations
will be received. Pressing and holding the button again for two
seconds will select the Distant setting (“LOC” will disappear from
the display panel) and the radio will stop at a wider range of
signals, including weaker (more distant) stations.
