128-7766
2 of 2
© 2006 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788
128-7766
KEYLESS ENTRY
1. The Lock button on the transmitter is used to lock the vehicle's doors,
the Unlock button is used to unlock the vehicle's doors. To lock or unlock
the doors simply press and release the desired function button one
time. As a keyless entry unit, for your convenience, the parking lights
will flash once when the doors are locked and twice when the door are
unlocked.
REMOTE CAR FINDER
The Lock or Unlock buttons are also used to access the car finder
mode. This feature is particularly useful in a crowded parking lot where
finding your car may be difficult. To access the car finder mode, while
within range of your car, simply press and hold either the lock or unlock
button of your transmitter for three seconds. The parking lights will begin to flash
making your vehicle more visible. The lights will stop automatically after 30
seconds. If you wish to turn off the car finder mode prior to the expiration of the 30
second timer, press and release either the lock or unlock button of your transmitter one
time
REMOTE TRUNK RELEASE
If you have electric trunk release in your vehicle and the remote trunk release option was
added to your vehicle, simply press and hold the Key/Trunk button of your keychain
transmitter for 4 seconds or until the electric trunk of your vehicle opens. . .
REMOTE STARTING THE VEHICLE
This unit will not start the vehicle if any one of the following situations exists;
The vehicle's hood lid is opened. The gear shift selector is not in Park.
The brake pedal is depressed. The safety control switch is in the Off position.
1. To start the vehicle, press and release the Key/Trunk button two times within 2
seconds. The vehicle will start and remain running for the pre-programmed 5,10,15,20
minute run cycle. As a visual indication, the parking lights will flash or remain on
depending on the setting by your installation center.
2. When you arrive at the vehicle, turn the ignition key to the ON position (not the spring
loaded start position), then step on the brake pedal to disengage the remote starter.
The vehicle will continue to run, but now on it's own power.
NOTE:
The engine will stop running before the pre-programmed run cycle has expired if
you perform any one of the following functions;
Press and release Key/Trunk button on the keychain transmitter two times within
2 seconds.-Depress the brake pedal. - Open the vehicle's hood -Place the unit
in the safety control disabled mode.
PRLED SAFETY CONTROL SWITCH
The Push-Button LED control switch allows you to temporarily disable the remote starting function of
the system. This recommended whenever the vehicle is being serviced. To place the system in the
service mode:
1) With the system disarmed/unlocked, and the ignition switch off Press and Hold the PRLED on.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED begins to flash two short flashes followed by one long flashes and continues this
pattern until returned to normal mode of operation.
This puts the unit into the R/S Override mode indicating that the remote start is in the service mode
and will not start from RF or any other input Posse or otherwise.
To Exit R/S Override Mode
1) With the system disarmed, Press and Hold the PRLED on.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED turns off indicating that the R/S unit is fully functional one again.
FUNCTION SETTING CHART
To be completed by installer
Run Time
5 Min
10 Min
15 Min
20 Min
Door Lock Timer
1 Sec/1 Sec
3.5
1 Sec/Dbl 1 Sec
Lights
Pulse
Steady
