7
FEATURE
ACTION TO PERFORM
RESPONSE FROM SYSTEM
LED FLASH PATTERN
To
Turn the Ignition Switch ON
LED Turns OFF
Enter
Toggle the Valet/Program/Manual Override Switch
The
ON then OFF 3 Times
1 Siren/Horn Chirp & 1 LED Flash
Programming Within 3 seconds,
Mode
turn the Ignition Switch OFF, then ON
1 Short Chirp, and 1 Long Chirp
First
Press Transmitter Button 1 to Change Feature
1 Chirp = Passive Arming ON
1 Flash, Pause, Repeat
2 Chirps = Active Arming ON
Second
Press Transmitter Button 1 to Change Feature
1 Chirp = Ign Locking ON
2 Flashes, Pause, Repeat
2 Chirps = Ign Locking OFF
Third
Press Transmitter Button 1 to Change Feature
1 Chirp = Ign Unlocking ON
3 Flashes, Pause, Repeat
2 Chirps = Ign Unlocking OFF
Fourth
Press Transmitter Button 1 to Change Feature
1 Chirp = Chirps ON
4 Flashes, Pause, Repeat
2 Chirps = Chirps OFF
Fifth
Press Transmitter Button 1 to Change Feature
1 Chirp = Passive Doorlock ON
5 Flashes, Pause, Repeat
2 Chirps = Passive Doorlock OFF
Sixth
Press Transmitter Button 1 to Change Feature
1 Chirp = Steady Output (siren)
6 Flashes, Pause, Repeat
2 Chirps = Pulsed Output (horn)
Seventh
Press Transmitter Button 1 to Change Feature
1 Chirp = 800ms Lock Pulse
7 Flashes, Pause, Repeat
2 Chirps = 3.5sec Lock Pulse
3 Chirps = 800ms Lock Pulse
800ms Double Unlock
You have now engaged the Programming Mode, and are set to adjust the First feature
This mode will time out automatically in 15 seconds, or can be cancelled by turning the Ignition Switch OFF
OR Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
OR Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
OR Turn the Ignition Switch OFF to exit the Programming Mode
NOTE: If you accidentally toggled past the feature you intended to adjust, you must exit and re-enter the mode.
OR Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
OR Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
OR Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
OR Toggle the Valet/Program/Manual Override Switch once to Advance to the next feature
COMPLETING THE INSTALLATION:
After you have confirmed the operation of the APS-45, and tested any and all optional features of the system:
1. Mount the control module up and behind the dash securing it in place with cable ties or screws. Be certain that the
chosen mounting location will not inhibit any of the controls of the vehicle.
2. Securely harness and tie all wiring up and away from all hot and moving parts that they may come in contact with
under the dash board or in the engine compartment areas.
CAUTION: Particularly avoid the area around the steering shaft and column, as wires can wrap around these
mechanisms and impair the safe operation of the vehicle.
3. Check the vehicle's wipers, lights, horn, etc... to insure proper operation.
4. Replace all panels that were removed during installation, and retest the system.
5. Explain the operation of the system and its various features to the end user if available, and place the Owner's
Manual on the dashboard for them to find and review.
NOTE: Once you've entered the program mode DO NOT allow more than 15 seconds to pass between steps, or
the programming mode will be terminated.
