128-6324
11 of 22
11) Guide the cable through the side
opening of the Mounting Tray and
plug it into the Monitor. Make sure
the connector locks into place. In-
sert the Monitor into the Mounting
Tray and secure the cable using
tie wraps or screws
12) Turn the Monitor around and in-
sert it into the Mounting Tray hous-
ing. Snap into place.
10) Lay the flaps of headrest material
down into the recess and insert
the Mounting Tray into the recess.
Check for fit. If it does not fit prop-
erly, you may need to remove
some more foam.
13) Connect the Monitor power input
plug to a DC power source (Red
plug +12 VDC, Yellow plug +12
VDC Constant and Black plug (-)
to ground).
14) Connect the external video source
output signal (from VCP/DVD, TV
Etc.) to the VIDEO IN jack. Test
the system to verify proper instal-
lation.
10
NOTE:If an Infrared Transmitter (op-
tional) is to be installed it must be con-
nected at this point as shown. This
must be done prior to the following
steps
NOTE: The Mounting Tray will need to
be secured to the headrest, either by
using tie straps, screws, etc.
