Audiovox KCD3180, Instruction Manual, Page: 8 / 19

- 7 -
MOUNTING INSTRUCTIONS
If your cabinet DOES have an overhang:
a) Eight screws are included with this
unit, but you will only need four of
them. Select the screw length which
will go completely through your
cabinet bottom, and extend at least
3/8" past the bottom of your cabinet
overhang.
b) This unit includes three sets of four
spacers of various lengths. The
spacers can be put together to form
longer spacers to accommodate
various cabinet overhang
thicknesses. Determine the best
combination of spacers which is
equal to or longer than the cabinet
overhang thickness.
c) Hold the unit up against the bottom of
the cabinet, and align the four holes on
the top of the unit with the screws.
Partially tighten each screw, but do
not fully tighten the screws until all of
them have been started.
d) Gently tighten each screw until they
are firmly holding the unit in place.
Go to
STEP 4.
(Continued from previous page)
(Continued on next page)
c) Mounting with spacers & double
side tape washers (optional). If
use the spacers, please use the
supplied tape washers to get easy
alignment.
Please remove one side of the
protective tab from the tape washers
first, and align the tape washers to
the holes and flush with them, then
remove another side of the protective
tab from the tape washer. Align the
spacers (optional) onto the tape
washer (see Figure 5 & 6).
d) Insert the four selected screws
through each hole from the inside
of the cabinet going down (see
Figure 7).
Mounting
Screw
Spacer
(Optional)
Figure 7
Spacer
(Optional)
Remove another side of the protective
tab and align the spacers onto them.
Remove one side of the protective
tab and tape to the holes.
Figure 6
e) Hold each screw head down and
push the unit and spacers onto the
screws, then hold the unit up until
spacers are firmly against the bottom
of the cabinet (and fully nested within
each other if you are using multiple
spacers for each screw).
f ) Partially tighten each screw, but do
not fully tighten the screws until all
of them have been started (see
Figure 8).
Figure 5