Audiovox Jensen Phase Linear UMP8015 Owner'S Manual Download

Page: 7 / 59

UMP8015

OPERATING INSTRUCTIONS

Tuning Control

Seek Tuning

Press either side of the

TUNE/TRACK/SKIP

(

) button (6) to tune rapidly to the next

available station and stop. If the radio is in the
local mode (indicated by “LOC” on the display
panel), the radio will stop at the next strong
local station, skipping the distant stations.

Manual Tuning

To manually select a radio station, press and
hold either side of the

TUNE/TRACK/SKIP

(

) button (6) until “MANUAL” appears

in the display. Within five seconds, use the up
or down tuning buttons to advance the unit one
digit higher or lower.

Mode Button (MODE)

Press the

MODE

button (7) to change between radio,

TV, AUX, CD or CD changer play. When a CD is
playing, you can press this button to revert to radio
operation.

Subwoofer (MODE)

To activate the subwoofer, press and hold the

MODE

button (7) for more than 2 seconds.

Audio Mute (MUTE)

Press the

MUTE

button (8) to mute the volume

from the system. “MUTE” will flash on the
display panel and the volume will be muted.
Press the

MUTE

button again or turn the

PUSH

SELECT

control (3) to return the volume level

to the setting in use before the Mute function
was activated.

FM Mono Select (MO/ST)

During FM radio operation, press the

MO/ST

button (9) to select mono or stereo reception of
the broadcast signal. Under normal reception
conditions, the unit should be left in the stereo
mode. When tuned to an FM stereo signal, the
“ST” icon appears on the display panel. If the
stereo signal is too noisy, press the

MO/ST

button to switch to monaural reception. To
return to stereo reception mode, press the
button again.

Local Button (LOC)

When stereo signals are weak or intermittent,
you can activate the Local mode by pressing
the

LOC

button (10). “LOCAL” and the “LOC”

icon appear on the display. This mode favors
access to local stations whose signals are
much stronger; thereby improving radio
reception. Press the

LOC

button again to

terminate Local receive mode (the “LOC” icon
disappears from the display panel).

Equalizer Selector (EQ)

The

button (11) applies preset sound effects

to the unit’s audio output signal. When pressed,
it will activate one of the following modes:
“FLAT”, “CLASSICS”, “POP M”, “ROCK M” or
“DSP OFF”. When the Equalizer function is
active, the bass and treble levels cannot be
changed. When the

function is not active,

the unit returns to the user-set bass and treble
level.

Pre-Set Scan/Auto-Store

(AMS)

Press the

AMS

button (12) to scan the stations

stored in either the AM or all three FM bands
(depending on which band is currently
selected). The unit stops at each pre-set station
for 10 seconds (the pre-set station number on
the display will flash as the corresponding
station is played). Press

AMS

again to stop pre-

set scan and listen to the selected frequency.

Press and hold the

AMS

button (12) for 2

seconds to activate the Auto-Store tuning
feature. This feature automatically scans and
enters up to 6 stations into the pre-set for the
band in use. If the radio is in the local mode,
only the stronger local stations are stored.
Activating the Auto-Store feature erases any
existing pre-set stations. This feature is most
useful when traveling in a new area where you
are not familiar with the local stations.