SETTING THE CLOCK
1.
Switch the vehicle ignition “on” and the radio “on".
2. If the radio frequency is shown on the LCD panel
bl
, press the Time/Frequency
Selector (T/F)
bs
momentarily so that the time display is shown.
3. With the time display on the LCD panel, press and hold the Time/Frequency
Selector (T/F)
bs
for approximately 2 seconds until the time display begins
flashing.
4. Within 5 seconds of the display beginning to flash, press the Down Tuning( )
side of the button
7
to adjust the hours, then the Up Tuning ( ) side of the
button
to adjust the minutes to the correct time.
5. After setting the correct time, press the Time/Frequency Selector (T/F) again or
wait 5 seconds for the display to stop flashing.
bt
RE-SET BUTTON
A re-set button is located on the front panel which must be activated by a pen tip or
other thin object as it is recessed to prevent accidental engagement. The re-set
circuitry is provided to protect the microprocessor circuitry and should only be
activated under the following circumstances as it will erase the time and station pre-
set memories.
1. Upon initial installation after all wiring is completed.
2. If there is a malfunction of any of the switches on the unit, pressing the re-set button
may clear the system and return to normal operation.
-4-