M-01334, Rev. B
Page 20
Step 11
Apply more sealant at each bolt and/or rivet
head to prevent leakage through the
mounting holes (See Figure 4-5).
Figure 4-5
Step 12
After the hardware has been tightened, generously weatherproof the hardware and
penetration points with sealant. Do not attempt to seal around the entire radome base.
Step 13
IMPORTANT!
Cut and remove the
shipping tie that locks the antenna in place
for shipping (see Figure 4-6). Failure to
remove this tie may result in damage to the
antenna motors and drive electronics.
Figure 4-6
