3
I. PREPARATION OF VEHICLE INTERIOR
1. Using the rear edge of O.E. sunroof opening as a
reference location, carefully measure & trim
headliner as shown.
Caution: Before cutting
headliner material, check for wiring or other
componentry above headliner. Cut only where
indicated.
Make sure that the 7" cut is centered
left to right in vehicle. See Figure 1.
DO NOT OVERCUT HEADLINER.
2. Remove and retain lens from middle O.E. dome light.
3. Remove and retain (3) three screws which secure
middle O.E. dome light. See Figure 2.
4. Construct a jumper harness that will connect
the vehicle’s dome light wires to the lights in
video system. Connect the white wire from
video system to the O.E. black/blue wire.
Connect the black wire from video system to
the chassis ground. See Figure 3.
5. Using a test light, test function of lights.
6. Install O.E. dome light in original manner.
FIGURE 1
FIGURE 2
FIGURE 3