13
Television Interference
The Audiovox ADC700 is shielded to minimize interference with TV signals.
However, in some instances, some interference may still be visible, particu-
larly with weak TV signals. Try the following corrective measures:
Position the ADC700 as far as possible from the television, the antenna
and the antenna cables. Use an extension cable, if necessary.
Adjust the orientation of the ADC700, the antennae cables and the TV
power cord to minimize interference.
Make sure that the, antenna connected to the television provides an
adequate (“snow free”) signal and that high quality, shielded antenna cable
is used.
TROUBLESHOOTING GUIDE:
PROBLEM: LACK OF OUTPUT
Possible Causes
Suggested Solution
Inverter not adequately warmed
Turn inverter power switch
up.
OFF and then ON again.
Repeat if necessary.
Battery voltage below 10.4 volts.
Recharge or replace battery.
Equipment being operated draws
Reduce load to maximum
too much power.
700 watts.