AUDIOTEL INTERNATIONAL
Ltd – Issue 3.1 (09/2004 )
Setting Up
Setting Up
18
SuperBroom Plus TA – Operating Manual
It is recommended that users initially adopt the following
search strategy. As experience is gained, users can develop
their own techniques and methods.
1 Set the maximum legal transmitter power for country of
operation at the set power menu during startup (UK = EU
High).
Note For non EU countries TX power is set using the rotary power
output control (9).
2 Begin with the SuperBroom set to
CLICK
,
COMPARE
and
Power mode (these are the default settings). Select DSP
mode by pressing Listen.
3 Set the
Volume
control to minimum, set the
Squelch
control
fully anticlockwise and connect the
headphones
. Adjust the
volume control to suit (using the Test Target to generate a
signal if necessary). The headphones are not needed at this
stage so can be worn around the neck
4 Pass the
Antenna Head
over all surfaces in the search area
so that, ideally, the distance between the antenna head and
a potential concealment is minimised (for effi cient operation
the minimum distance should not be less than 6 inches).
Repeat
coverage of an area after rotating the antenna head
through 90 degrees
5 If a target is detected the difference in second and third
harmonic signal strengths will be displayed on the Antenna
Head. Move the antenna until the COMPARE signal
strength reaches a maximum.
6 Search the identifi ed location for the device.
Battery Compartment Door
RetainingScrew
7
