Continous power rating at 4 Ohms per channel ...... 4 x 275 Watts RMS ...................................Impedance setting: 4 Ohms
Continous power rating at 2 Ohms per channel ...... 4 x 280 Watts RMS ...................................Impedance setting: 2 Ohms
Continous power rating at 1 Ohm per channel ....... 4 x 285 Watts RMS ...................................Impedance setting: 1 Ohm
Continous power rating, bridged at 4 Ohms ............ 2 x 550 Watts RMS ...................................Impedance setting: 2 Ohms
Continous power rating, bridged at 2 Ohms ............ 2 x 560 Watts RMS ...................................Impedance setting: 1 Ohm
TECHNICAL DATA
TROUBLE-SHOOTING
Damping factor..................................................... > 1000
Input impedance.................................................10 kOhm
Input sensitivity...............................................1,0 V - 8,0 V
Internal fuse..............................................................150 A
Weight net..............................................................11,5 kg
The BRAX MX4 is in protection mode and the respective LED lights up yellow.
Cause:
The speaker wiring is faulty (short circuit between the wires or to the chassis of the vehicle).
Remedy:
Check the speaker wires or the speakers themselves for short-circuiting (p.19 - 20).
Cause:
The impedance setting does not correspond to the impedance of the installed loudspeakers.
Remedy:
Check the impedance setting (p. 21).
22
Frequency response...................................10Hz - 80 kHz
Total harmonic distortion (THD).........................< 0,001%
TIM.....................................................................< 0,006%
Signal to noise ratio............................................> 110 dB
Dimensions (H x B x T) in mm...................79 x 360 x 360
