CR120A-COMBO -
120W B
LUETOOH
®
SOUND
SYSTEM
WITH
USB
PLAYER
AND
2
UHF
HANDHELD
MIC
English
20
4 -Description of the modules
4 - 1 : UHF receiving module
A1
- Volume control fader for the HF module. From OFF to full power
(clockwise).
A2
- Squelch control fader: allows you to configure the threshold in
case of HF signal interruption. The factory settings do not require
any modification.
A3&4
- Canal selection: allow you to browse through the 16
available frequencies.
A5
- Frequency display.
A6
- Radio Frequency indicator: this indicator is lit in red when the
emitting mic is ON.
A7
- Audio Frequency indicator: this indicator is lit in green when a
signal is being received.
A8
- ASC (Auto Synchro Connection) button: allows you to
synchronise a channel between the transmitter and receiver. Select
a channel (from 1 - 16), press the ASC button and put the IR (#6)
diode of your mic in front of the IR (#9) diode of your receiver.
A9
- IR diode. Allows you to synchronise your mic with the receiver.
B1
- Channel 1 input selector. Allows
you to decide if the player or the Aux
input will be active on channel 1 of the
mixer.
B2
- SD card slot.
B3
- Reader display.
B4
- IR diode to receive the remote
control commands.
B5
- USB mass storage socket for
USB key.
B6
- Command panel of the reader:
MODE:
Allows you to switch from USB/SD to
the Bluetooth
®
receiver: the display
will indicate «BT NOT LINK», and
«connecting» for a few seconds when
you switch to Bluetooth
®
MODE.
1
st
Bluetooth
®
pairing:
Switch to Bluetooth
®
mode. The display will indicate «BT NOT LINK», then «connecting...» for a few seconds.
Turn your Bluetooth
®
source ON and scan for devices.
Select «Bluetooth» in the list, and accept the pairing.
The CR12A-COMBO display should indicate the name of the connected device.
4 - 2 : USB/SD/Bluetooth
®
module
5
6
8
9
1
2
7
3
4
DOWN
UP
MUTE LEVEL
POWER-VOL
OFF
15
12
8
4
IR
AF
RF
1
2
6
3
4
5
