2SHUDWLRQ
Page 7
Loading a Disc
Insert one CD into the slot. The disc information will now display. After
reading the track information the disc will stop.
Playing a Disc
Press to play a disc.
Press to pause a disc, press again to resume play
Press to stop the disc
Press to eject the disc
Next/Previous Track
Press
to move to the next track.
Press
to once to replay the current track.
Press
/
repeatedly to move through the tracks forward or back
on track at a time.
If you exceed the number of tracks on the disc, the player will wrap
round and play from track 1.
If you go past track 1, the player will wrap round and reverse search
from the final track on the disc.
Direct selection of the tracks from the handset
Select the wanted track directly from the remote key pad. The disc
will play forward from the chosen track. If you choose a single digital
track (e.g.1) in a disc which contains more than 10 tracks, the player
will pause briefly, waiting for you to enter a second digital. If none is
entered, player will commence from the entered single-digit track. If
the choice is invalid the display reverts to the previous state.
Note: You can preselect a track before you load a disc. When the disc
is loaded the player will play from the selected track.
Switching On and Off
Connect power to all system units. Switch the mains on. Switch on all source units
including the 8300CDQ. Switch on the power amplifiers.
When switching off:
switch off the amplifier first before switching off the
8300CDQ unless they are trigger enabled.
When switching on:
The power LED illuminates.
Standby Mode
Audiolab 8300CDQ will be in standby mode when power on. Press the button
to bring 8300CDQ out of standby, the power indicator LED becomes brighter,
after a short period the units boots up,the display shows the welcome screen
You can activate the ‘auto standby’ function by holding the button down for 3
seconds. Using this ‘auto standby’ function, 8300CDQ will automatically go into
standby mode when there is no signal input or operation for 20 minutes, and the
power indicator LED becomes dim .
Altering the Volume Level
Press the VOL +/- keys on front panel to alter the level.
The range is -80dB to +3dB, 0dB is nominally 2.0Vrms .
The factory default volume is -20dB. If the volume is set to lower than -20dB when
the unit is closed, the default volume will be last used value when the unit next
boots up. If the volume is set to higher than -20dB, the default volume will be
-20dB when the unit next boots up.
Playing a CD
If not already selected, press the DIGITAL key on the handset to cycle the CD
input, or cycle the SEL key on the front panel to select the CD input.
&'
G%
1R'LVF
&'
G%
/RDGLQJ
&'
G%
5HDGLQJ
&'
G%
7UN
&'
G%
7UN
&'
G%
(MHFW
