page 5
More Highlights
Summable Outputs
The LCQ-1 has the capability to combine together multiple (2, 4, or 6)
input signals from the factory source unit into 2 channels. In some vehicles
there is an actively crossed over tweeter, midrange, and woofer all in the
front of the vehicle. The LCQ-1 lets you take all of those signals and sum
them together to get a high quality, full range, pre- amp signal. Simply move
the summing jumper located under cover and near knobs for the desired
channel into the “Sum” position. If the green LED for that channel is on, you
know it is being summed into the main output.
AutoMode Inputs
We have equipped your LCQ-1 with an AutoMode input that takes the
channel 2 (rear) input signal and automatically feeds it to the channel 3 out-
puts to drive a subwoofer amp and crossover. This means your LCQ-1 will
accept two input channels (say, Front and Rear) and give you three output
channels (Front, Rear, and Sub).
Optional Remote Level Control/EQ Switch
The ACR-2 is a multi-function remote that gives you control over the level
of the Channel 3/Subwoofer output so you can balance the bass level with
the rest of the system. An additional feature of the ACR-2 dash remote is that
it allows the equalization to be switched in and out of the audio circuit by
tapping the switch. You can hear the system before and after the EQ adjust-
ments.
ACR-2 Dash Control (Purchased Separately)
Placement And Mounting
The ACR-2 dash control may be mounted under the dash using its own
bracket or through a custom hole in the dash. It should be within reach of the
driver and in a spot where the LED is plainly visible.
Bracket Installation
The dash control mounts with two screws, which attach to the underside of
the dashboard. Slide under the dash and place the dash control in its mount-
ing position, mark the two mounting holes, drill pilot holes, and secure with
two screws.
Custom Installation
For that custom, finished look, the dash control can be
flush mounted directly on the dash-board (or any-
where else). Referencing the figure above,
disassemble the dash control from the
mounting bracket. Start by pushing the
LED from its holder followed by
removing the circuit board and
rotary control from the bracket.
Drill a 9/32 hole in the dash-
board for the control along with
a 1/8 hole for the lock tab and
a 13/64 hole for the LED holder.
Reassemble the dash control components on the dashboard.
Dash Control Assembly
Summary of Contents for LCQ-1
Page 10: ......
