Version 5.4
61
May 2008
SIP Hardware Installation Manual
4. Maintenance and Repair
4
Maintenance and Repair
This section provides information on the following hardware maintenance and repair
operations:
Replacing blades/RTMs (refer to ''Replacing Blades/RTMs'' on page
Replacing the Power Supply (PS/DC/3K) module (refer to ''Replacing the Power
Supply Module'' on page
Replacing the Power Entry (PEM/DC/3K) module (refer to ''Replacing the Power Entry
Module'' on page
Replacing the Fan Tray module (refer to ''Replacing the Fan Tray Module'' on page
Replacing the Air Filter (refer to ''Replacing the Air Filter'' on page
Replacing 155-Mbps Optical SFP Transceiver Modules (refer to ''Replacing 155-Mbps
Optical SFP Transceiver Modules'' on page
4.1 Ensuring
ESD
Protection
Please read the warning bulletin below before performing hardware maintenance
procedures:
Electrical Component Sensitivity
Electronic components on printed circuit boards are extremely sensitive to
static electricity. Normal amounts of static electricity generated by clothing can
damage electronic equipment. To reduce the risk of damage due to
electrostatic discharge (ESD) when installing or servicing electronic equipment,
it is recommended that anti-static earthing straps and mats be used.
Note:
Place all removed components in an anti-static bag.
¾
Before removing or inserting components from the chassis, take
these 2 steps:
1.
Locate the two ESD connectors on the chassis - one is located on the right rack-
mounting flange; the other is located on the rear panel of the Fan Tray module.
2.
Attach yourself to an ESD wrist strap and then connect the other end to one of the
ESD connectors (mentioned in Step 1), using a banana plug or an alligator clip.