AudioCodes MP-26 series, User Manual

Page: 407 / 464

User's Manual 24. Getting Started
Version 4.4.0 407 MP26x/MP27x
5. Define the following line settings:
•
User ID: phone number (extension) of the device handset
•
Display Name: String displayed to remote parties as your caller ID
•
Authentication User Name: User name (obtained from your service provider)
used when sending a response to Unauthorized or Proxy Authentication
Requested (401/407)
•
Authentication Password: Password (obtained from your service provider)
used when sending a response to Unauthorized or Proxy Authentication
Requested (401/407)
24.6 Registering the Handset to Base Unit
Before you can use your handset, you need to register it to the base unit. Up to five
handsets can be registered to the base unit. If the handset is not registered to the base
unit, the following is displayed on its screen:

icon flashes

“Out of Range” message appears in idle state

To register the handset to the base:
1. Press the Menu softkey.
2. Press the navigation keys to scroll to the Registration icon, and then
press the Select softkey.
3. On the M-264 base unit, press the DECT LED button until (2 – 5 seconds) it starts
flashing green; the base unit enters registration mode. (The registration mode remains
active for 30 seconds, after which the
DECT LED stops flashing. Therefore, proceed
to the next step before this interval expires.)
4. Press the navigation keys to choose the base unit (i.e., “Base 1”) to which you
want to register the handset, and then press the Select softkey; the registration
process begins and the “Registering - Waiting” is displayed.
5. When the handset identifies the base, it displays its radio frequency (RF) identification
(each base has a unique RF ID). Click the
Accept softkey to confirm (or press the Rej
softkey to cancel registration).
6. On some handsets, you are prompted to enter a PIN code. The default PIN code is
0000 (see Section
31.2 on page 445 for defining the PIN code).
If the handset successfully registers to the base, a confirmation tone is heard and the
icon stops flashing. The handset is automatically allocated the next available handset
number. This handset number is displayed on the handset screen in idle mode. The base
unit to which the handset is successfully registered is marked with an asterisk “*” in the
Registration menu (see Section 30.8 on page 440 ).