AudioCodes MediaPack, Installation Manual

Page: 17 / 58

Version 6.0 17 March 2010
Installation Manual 2. Installing the Device
3. Attach the shelf to the rack using four standard rack screws (not supplied).
Figure 2-5: MP-11x Rack Mount
Table 2-3: MP-11x Rack Mount
Item # Functionality
1 Standard rack holes used to attach the shelf to the rack.
2 Eight shelf-to-device screws.
2.1.4 Cabling the MP-11x
This section describes the MP-11x cabling procedures:
¾
To cable the MP-11x:
„ Connecting to the Ethernet network (refer to 'Connecting MP-11x to the Network' on
page
18 ).
„ Connecting to FXS/FXO devices (refer to 'Connecting MP-11x to FXS /FXO Devices'
on page
18 ).
„ Cabling the FXS Lifeline (refer to 'Cabling the MP-11x/FXS Lifeline' on page 19 ).
„ Serial connection to a computer (refer to 'Connecting MP-11x RS-232 Port to a PC' on
page
20 ).
„
Connecting to the power supply (refer to 'Connecting MP-11x to Power' on page 21 ).
Once you have completed the above hardware installation steps and after powering-up the
MP-11x, the
Ready and Power LEDs on the front panel light up green (after a self-testing
period of about two minutes). Any malfunction in the startup procedure changes the Fail
LED to red and the Ready LED is turned off (for details on the MP-11x LEDs, refer to
'Monitoring Front-Panel LEDs' on page 55 ). Once you have cabled the device, you can
begin configuring the device (refer to 'Configuring the Device' on page 35 ).