AudioCodes mediapack MP-500, User Manual

Page: 401 / 574

Version 5.8 401 October 2009
SIP User's Manual 6. Configuration Parameters Reference
6.12.3 Metering Tone Parameters
The metering tone parameters are described in the table below.
Table 6-47: Metering Tone Parameters
Parameter Description
Web: Generate Metering
Tones
EMS: Metering Mode
[PayPhoneMeteringMode]
Determines the method used to configure the metering tones that are
generated to the Tel side.
ƒ
[0] Disable = Metering tones aren't generated (default).
ƒ
[1] Internal Table = Metering tones are generated according to the
internal table configured by the parameter ChargeCode.
Notes:
ƒ
This parameter is applicable only to FXS interfaces.
ƒ
If you select 'Internal Table', you must configure the 'Charge Codes
Table' (refer to ''Configuring the Charge Codes Table'' on page
172 ).
Web: Metering Tone Type
EMS: Metering Type
[MeteringType]
Defines the metering tone (12 or 16 kHz) that is generated by FXS
interfaces.
ƒ
[0] 12 kHz = 12-kHz metering tone (default).
ƒ
[1] 16 kHz = 16-kHz metering tone.
Notes:
ƒ
A suitable (12 or 16 KHz) FXS Coefficient file must be used for
FXS interfaces.
ƒ
For this parameter to take effect, a device reset is required.
Web: Charge Codes Table
EMS: Telephony FXS And FXO (SIP) Parameters Provisioning > Charge Codes
[ChargeCode] This ini file table parameter configures metering tones (and their time
intervals) that the device's FXS interface generates to the Tel side.
The format of this parameter is as follows:
[ChargeCode]
FORMAT ChargeCode_
Index = ChargeCode_ EndTime1 ,
ChargeCode_ PulseInterval1 , ChargeCode_ PulsesOnAnswer1 ,
ChargeCode_ EndTime2 , ChargeCode_ PulseInterval2 ,
ChargeCode _PulsesOnAnswer2 , ChargeCode_ EndTime3 ,
ChargeCode_ PulseInterval3 , ChargeCode_ PulsesOnAnswer3 ,
ChargeCode_ EndTime4 , ChargeCode_ PulseInterval4 ,
ChargeCode_ PulsesOnAnswer4 ;
[\ChargeCode]
Where,
ƒ
EndTime = Period (1 - 4) end time.
ƒ
PulseInterval = Period (1 - 4) pulse interval.
ƒ
PulsesOnAnswer = Period (1 - 4) pulses on answer.
For example:
ChargeCode 1 = 7,30,1,14,20,2,20,15,1,0,60,1;
ChargeCode 2 = 5,60,1,14,20,1,0,60,1;
ChargeCode 3 = 0,60,1;
ChargeCode 0 = 6, 3, 1, 12, 2, 1, 18, 5, 2, 0, 2, 1;